Walkways and access clearChoose one
What is wrong?Short answer
Shown when “Walkways and access clear” is “Defect”
Belt surface: no cuts, tears or worn patchesChoose one
What is wrong?Short answer
Shown when “Belt surface: no cuts, tears or worn patches” is “Defect”
Belt edges: no frayingChoose one
What is wrong?Short answer
Shown when “Belt edges: no fraying” is “Defect”
Length of the worst belt damage (m)Number
Optional. With the belt stopped and isolated, measure along the belt from a photo using a known length in the same plane, such as the belt width, or use a tape.
Shown only when the answers above make it relevant
Belt runs centrally (tracking)Choose one
What is wrong?Short answer
Shown when “Belt runs centrally (tracking)” is “Defect”
Belt joint or fastenersChoose one
What is wrong?Short answer
Shown when “Belt joint or fasteners” is “Defect”
Rollers and idlers turn freely, none seizedChoose one
What is wrong?Short answer
Shown when “Rollers and idlers turn freely, none seized” is “Defect”
Head and tail drumsChoose one
What is wrong?Short answer
Shown when “Head and tail drums” is “Defect”
No spillage or build-up under the beltChoose one
What is wrong?Short answer
Shown when “No spillage or build-up under the belt” is “Defect”
Fixed guards in place at drives, drums and nip pointsChoose one
What is wrong?Short answer
Shown when “Fixed guards in place at drives, drums and nip points” is “Defect”
Pull cord, where fitted, runs head to tail and stops the beltChoose one
What is wrong?Short answer
Shown when “Pull cord, where fitted, runs head to tail and stops the belt” is “Defect”
Emergency stop buttonsChoose one
What is wrong?Short answer
Shown when “Emergency stop buttons” is “Defect”
Isolation point clearly marked and lockableChoose one
What is wrong?Short answer
Shown when “Isolation point clearly marked and lockable” is “Defect”
Checks OKWorked out by the form
DefectsWorked out by the form
Not applicableWorked out by the form
Guard, stop or isolator defectsWorked out by the form
- WarningA missing or damaged guard. Keep the conveyor out of use until it is refitted or repaired: PUWER regulation 11 requires guards to be maintained in an efficient state and in good repair.
Shown when “Fixed guards in place at drives, drums and nip points” is “Defect”
- CheckPUWER regulation 16 requires readily accessible emergency stop controls where appropriate. Report a faulty stop or pull cord before the conveyor is used.
Shown only when the answers above make it relevant
Photos (from outside the guards)Photos
Walk Cam: conveyor belt inspectionWalk Cam video with voice-to-text
Optional. Film the four guided points on the SiteSurvey app; each clip keeps its spoken note.