Skip to main content

Walk Cam · 4 min read

AI Visual Inspector: questions and fixes

Answers to the common AI Visual Inspector questions: switching it on, file limits, saving before examples, the AI budget, and what to do when a check or test stops.

LMLee Moss · DirectorUpdated 6 November 2026
Quick fixes for the AI Visual Inspector in the web dashboard: why AI inspection might be missing, why examples need a saved template, the 50 MB file limit, what counts towards the AI budget, and what to do when a test run, a check or an AI draft does not finish.
  1. 01

    I can't see AI inspection or Turn on AI

    AI Visual Inspector is in beta and is switched on per company. Until it is on, + Add New offers only Simple inspections and the template menu has no Turn on AI. Contact support to have it switched on for your company.

  2. 02

    Step 5 says Save the template first to add examples

    Examples belong to a saved template, because Check the AI runs them against the saved version. Select Create template (or Save template), then go back to step 5. If you then change a check or rule, Check the AI shows Save and check the AI and saves for you first.

  3. 03

    That file is over 50 MB

    Test on a clip and examples take a photo (JPG, PNG or WebP) or a video (MP4 or MOV) up to 50 MB. Trim the clip to the few seconds that show the point, or export it at a lower resolution. 720p is plenty for the AI.

  4. 04

    Test on a clip says Give this point a question in step 3 first

    A point needs its What to film question before it can be tested. Open the point in step 3, type the question, then go back to step 4.

  5. 05

    Check the AI stopped part way

    Checks run one at a time and each can take up to a minute. If one fails, the run stops and the message says which example. The examples checked before it keep their results. Select Check the AI again to carry on with the ones not checked yet.

  6. 06

    What counts towards the AI budget

    Every call to the AI counts: a Let me help you draft, each Test on a clip run, and each example checked by Check the AI or Re-check all. Clips checked on site during a walk count too. Re-check all runs every example again, so use it after a real change rather than out of habit. If an AI action is refused because the budget is used up, contact support.

  7. 07

    My test runs disappeared

    Test on a clip keeps its runs only until you reload the page. Nothing from a test run is saved. Use examples in step 5 for anything you want to keep and check again later.

  8. 08

    The AI keeps saying Can't tell

    The clip is not showing what the checks need. Read its More evidence needed or Not seen lines, then either change the filming instructions so the inspector films that, or split the point in two so each clip has less to show. Measurements need a gauge or ruler in shot.

Good to know

  • ✓Start a new AI template from Browse library or Let me help you; it is the quickest way to see well-worded checks and rules.
  • ✓Clips are sent to Google Gemini for assessment and are not used to train Google's models.

Was this guide helpful?

Your feedback helps us improve support content.